Repara tus cosas Comunidad Tienda

Tatung TAC-6G Light Element Replacement

Introducción

The device contains small lights that indicate whether the rice is cooking or being kept warm. In this guide we will the expose the light bulb circuitry to check if it is broken and replace the light bulbs if necessary.

Qué necesitas

  1. Tatung TAC-6G Light Element Replacement, Light Element: paso 1, imagen 1 de 1

    • Start with the device standing upright.

    Editar

  2. Tatung TAC-6G Light Element Replacement: paso 2, imagen 1 de 1

    • Remove the 11mm Phillips screw from below the power component panel.

    Editar

  3. Tatung TAC-6G Light Element Replacement: paso 3, imagen 1 de 1

    • Pull the panel away from the rice cooker.

    • Remove the 9mm Phillips screw from behind the power component dashboard that is connected to the light plate.

    Editar

  4. Tatung TAC-6G Light Element Replacement: paso 4, imagen 1 de 1

    • Pull the light plate from the power component panel.

    Editar

  6. Tatung TAC-6G Light Element Replacement: paso 5, imagen 1 de 1

    • Flip the rice cooker device upside down.

    Editar

  7. Tatung TAC-6G Light Element Replacement: paso 6, imagen 1 de 2 Tatung TAC-6G Light Element Replacement: paso 6, imagen 2 de 2

    • Remove the one 7mm Phillips screw from the side of the brass panel

    • Lift the brass plate off of the device and set it aside.

    Editar

  8. Tatung TAC-6G Light Element Replacement: paso 7, imagen 1 de 1

    • Remove the 7mm Phillips screw holding the white and maroon colored wires that are connected to the heating element.

    Editar

  9. Tatung TAC-6G Light Element Replacement: paso 8, imagen 1 de 1

    • Remove the 10mm Phillips screw that connects the white, blue and black wires to the white plastic piece in the corner of the device.

    Editar

  10. Tatung TAC-6G Light Element Replacement: paso 9, imagen 1 de 1

    • Remove the 7mm Phillips screw that connects two white wires and one red wire to the heating "warm" switch.

    Editar

  11. Tatung TAC-6G Light Element Replacement: paso 10, imagen 1 de 1

    • Using your hand, pull out the light plate with the maroon red and black wires.

    Editar

  12. Tatung TAC-6G Light Element Replacement: paso 11, imagen 1 de 1

    • Replace the light plate dashboard.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Un comentario

Reverse the steps for reassembly.

Tom Anderson - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 4

Todo El Tiempo: 619