Saltar al contenido principal

Swann Wi-Fi Indoor Security Camera Infrared LED Replacement

Qué necesitas

  1. Swann Wi-Fi Indoor Security Camera Infrared LED Replacement, Case: paso 1, imagen 1 de 3 Swann Wi-Fi Indoor Security Camera Infrared LED Replacement, Case: paso 1, imagen 2 de 3 Swann Wi-Fi Indoor Security Camera Infrared LED Replacement, Case: paso 1, imagen 3 de 3
    • Use the Phillips #0 to remove the screw located on the back of the camera above the mount.

    • Slide the mount out from the bottom of the device.

  2. Swann Wi-Fi Indoor Security Camera Infrared LED Replacement: paso 2, imagen 1 de 1
    • Remove the back of the case by placing a iFixit opening tool underneath the edge of the case and prying it up.

  3. Swann Wi-Fi Indoor Security Camera Infrared LED Replacement: paso 3, imagen 1 de 1
    • Carefully remove the back of the case without pulling the cables connected to the motherboard and the speaker on the back of the case.

  4. Swann Wi-Fi Indoor Security Camera Infrared LED Replacement, Infrared LED: paso 4, imagen 1 de 1
    • Facing the inside of the front case, unscrew the three 2.0 mm Phillips #0 black screws located on the back of the LED ring.

  5. Swann Wi-Fi Indoor Security Camera Infrared LED Replacement: paso 5, imagen 1 de 2 Swann Wi-Fi Indoor Security Camera Infrared LED Replacement: paso 5, imagen 2 de 2
    • Release the clip connection connecting the LED ring to the motherboard.

    • Remove the infrared LED assembly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 5

Ultimos 30 días: 19

Todo El Tiempo: 1,020