Saltar al contenido principal

Introducción

This explains what will be necessary to not only replace the back panels, but also open the SwagTron T1 to have access to other parts.

Partes

No se especificaron partes.

  1. Ensure that the SwagTron is off.
    • Ensure that the SwagTron is off.

    • Turn the SwagTron upside down to see the underside.

  2. Unscrew the eighteen 10mm screws that secure the back panels using a Phillips #2 screwdriver. The screws are tightly in place. It will take effort to screw them out. The panel is still attached to the SwagTron by wires that go to the motherboard.
    • Unscrew the eighteen 10mm screws that secure the back panels using a Phillips #2 screwdriver.

    • The screws are tightly in place. It will take effort to screw them out.

    • The panel is still attached to the SwagTron by wires that go to the motherboard.

    • Carefully lift the panels off

  3. Follow the wires from the panels to the motherboard. You may need to cut any zip ties that are holding the wires together. There is one connection on the battery side and three on the other side that must be removed.
    • Follow the wires from the panels to the motherboard.

    • You may need to cut any zip ties that are holding the wires together.

    • There is one connection on the battery side and three on the other side that must be removed.

    • These connections may be difficult to remove. Try to securely press the connection and pull firmly.

    • Your back panels are now completely removed.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Adrian Abarca

Miembro Desde 18/04/17

270 Reputación

2 Guías creadas

Equipo

Cal Poly, Team S17-G5, Banghart Spring 2017 Miembro de Cal Poly, Team S17-G5, Banghart Spring 2017

CPSU-BANGHART-S17S17G5

5 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 9

Todo El Tiempo: 296