Starbucks Barista Ready Light Replacement

Introducción

The ready light is a simple LED that shows when the Barista has heated up to its needed temperature. This LED may burn out or its connectors may loosen.

Qué necesitas

Paso 1 Ready Light

Starbucks Barista Ready Light Replacement, Ready Light: paso 1, imagen 1 de 2

Starbucks Barista Ready Light Replacement, Ready Light: paso 1, imagen 2 de 2

Unscrew the 6 screws from the back panel.
Remove the back panel.

Editar

Paso 2

Starbucks Barista Ready Light Replacement: paso 2, imagen 3 de 3

Locate the ready light.
Gently push the fixture against the Barista wall.
Pull the fixture straight up to release it.
Note: The fixture works as a spring.
Note: The green cover from the front panel will "pop" off. Do not lose the green cover.
Disconnect the wire lead connectors.
Remove the ready light unit (fixture).

Editar

Paso 3

Replace the old LED with a new LED.
To put back, match the green cover to the slot of the LED fixture, then slide the fixture down against the barista wall.

Editar