Partes

No se requieren partes.

  1. Flip the phone over so that the screen is facing down.
    • Flip the phone over so that the screen is facing down.

  2. Push the gray lever up towards the top of the phone. Pull up on the battery pack and completely separate it from the phone.
    • Push the gray lever up towards the top of the phone.

    • Pull up on the battery pack and completely separate it from the phone.

  3. Locate the 5 screws around the back casing. Use a three-prong screw bit to remove all 5 screws
    • Locate the 5 screws around the back casing.

    • Use a three-prong screw bit to remove all 5 screws

  4. Use the plastic opening tool and slide it around the phone to pull apart the front and back casing.
    • Use the plastic opening tool and slide it around the phone to pull apart the front and back casing.

  5. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  6. Separate the two cases.
    • Separate the two cases.

  7. Use the plastic opening tool to remove the motherboard from the front case.
    • Use the plastic opening tool to remove the motherboard from the front case.

  8. Locate the 4 white clips of the dispaly. Locate the 4 white clips of the dispaly.
    • Locate the 4 white clips of the dispaly.

  9. Using the plastic opening tool, pull the white clips of the display away from the printed circuit board to unclip display. Using the plastic opening tool, pull the white clips of the display away from the printed circuit board to unclip display.
    • Using the plastic opening tool, pull the white clips of the display away from the printed circuit board to unclip display.

  10. Grasp the display on both sides and carefully pull the display off of the printed circuit board. Grasp the display on both sides and carefully pull the display off of the printed circuit board.
    • Grasp the display on both sides and carefully pull the display off of the printed circuit board.

  11. Using the plastic opening tool, carefully remove the yellow film covering the display connector. Do not damage the yellow film. Ensure that it stays in one piece and does not tear.
    • Using the plastic opening tool, carefully remove the yellow film covering the display connector.

      • Do not damage the yellow film. Ensure that it stays in one piece and does not tear.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Equipo

Clemson, Team 13-5, Benson Fall 2013 Miembro de Clemson, Team 13-5, Benson Fall 2013

CLEM-BENSON-F13S13G5

3 Miembros

12 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 119