Saltar al contenido principal

Introducción

Sometimes rough play can cause the wheel to break or not spin anymore. This guide will show you how to remove the wheel.

  1. lay the Hatchimal on its side.
    • lay the Hatchimal on its side.

  2. Using the plastic opening tool, push in on the purple clip.
    • Using the plastic opening tool, push in on the purple clip.

  3. Pull the wing off of the hatchimal.
    • Pull the wing off of the hatchimal.

    • The wing should come off with little resistance.

  4. Cut the fur retaining zip-tie with a pair of scissors. Cut the fur retaining zip-tie with a pair of scissors.
    • Cut the fur retaining zip-tie with a pair of scissors.

  5. Lift the fur up until it can't go further. Lift the fur up until it can't go further.
    • Lift the fur up until it can't go further.

  6. Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora

    Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora
  7. Use the spudger tool to push up on the black clip to free it. Pull the clip out. Pull the clip out.
    • Use the spudger tool to push up on the black clip to free it.

    • Pull the clip out.

  8. Lift fur up to reveal the next set of clips. Insert a spudger to push up on the black clip to free it. Pull out the clip.
    • Lift fur up to reveal the next set of clips.

    • Insert a spudger to push up on the black clip to free it.

    • Pull out the clip.

  9. Lift the fur up and over the Hatchimals Head. Remove the six 12mm Phillips #00 screws from then body.
    • Lift the fur up and over the Hatchimals Head.

    • Remove the six 12mm Phillips #00 screws from then body.

  10. Pull the casing apart. Remove the yellow speaker cable.
    • Pull the casing apart.

    • Remove the yellow speaker cable.

  11. Remove the three 7mm Phillips #00 screws from the head. Remove the wheel base and the circuit board carefully not to damage the spring. Remove the wheel base and the circuit board carefully not to damage the spring.
    • Remove the three 7mm Phillips #00 screws from the head.

    • Remove the wheel base and the circuit board carefully not to damage the spring.

  12. Push the six black fur clips out using the spudger. Remove the fur completely.
    • Push the six black fur clips out using the spudger.

    • Remove the fur completely.

  13. Lift up and remove the light blue plastic casing. Lift up and remove the light blue plastic casing.
    • Lift up and remove the light blue plastic casing.

  14. Remove the six 7mm Phillips #00 screws. Remove the six 7mm Phillips #00 screws.
    • Remove the six 7mm Phillips #00 screws.

  15. Remove the purple plastic casing. It should come off with little resistance. Remove the wheel.
    • Remove the purple plastic casing. It should come off with little resistance.

    • Remove the wheel.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Humaid Alhajri

Miembro Desde 14/02/18

97 Reputación

1 Guía escrita

Equipo

USF Tampa, Team S1-G5, Nance Spring 2018 Miembro de USF Tampa, Team S1-G5, Nance Spring 2018

USFT-NANCE-S18S1G5

3 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 3

Últimos 30 Días: 13

Todo El Tiempo: 254