Saltar al contenido principal

Introducción

Toys go through a lot, and many times they get dirty. This guide will show you how to remove the fur for further cleaning or full replacement.

  1. lay the Hatchimal on its side.
    • lay the Hatchimal on its side.

  2. Using the plastic opening tool, push in on the purple clip.
    • Using the plastic opening tool, push in on the purple clip.

  3. Pull the wing off of the hatchimal.
    • Pull the wing off of the hatchimal.

    • The wing should come off with little resistance.

  4. Cut the fur retaining zip-tie with a pair of scissors. Cut the fur retaining zip-tie with a pair of scissors.
    • Cut the fur retaining zip-tie with a pair of scissors.

  5. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  6. Lift the fur up until it can't go further. Lift the fur up until it can't go further.
    • Lift the fur up until it can't go further.

  7. Use the spudger tool to push up on the black clip to free it. Pull the clip out. Pull the clip out.
    • Use the spudger tool to push up on the black clip to free it.

    • Pull the clip out.

  8. Lift fur up to reveal the next set of clips. Insert a spudger to push up on the black clip to free it. Pull out the clip.
    • Lift fur up to reveal the next set of clips.

    • Insert a spudger to push up on the black clip to free it.

    • Pull out the clip.

  9. Lift the fur up and over the Hatchimals Head. Remove the six 12mm Phillips #00 screws from then body.
    • Lift the fur up and over the Hatchimals Head.

    • Remove the six 12mm Phillips #00 screws from then body.

  10. Pull the casing apart. Remove the yellow speaker cable.
    • Pull the casing apart.

    • Remove the yellow speaker cable.

  11. Remove the three 7mm Phillips #00 screws from the head. Remove the wheel base and the circuit board carefully not to damage the spring. Remove the wheel base and the circuit board carefully not to damage the spring.
    • Remove the three 7mm Phillips #00 screws from the head.

    • Remove the wheel base and the circuit board carefully not to damage the spring.

  12. Push the six black fur clips out using the spudger. Remove the fur completely.
    • Push the six black fur clips out using the spudger.

    • Remove the fur completely.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

USF Tampa, Team S1-G5, Nance Spring 2018 Miembro de USF Tampa, Team S1-G5, Nance Spring 2018

USFT-NANCE-S18S1G5

3 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 8

Todo El Tiempo: 183