Sony Xperia XA Motherboard Replacement

Introducción

You will need to use a source of heat. You may need to buy adhesive for the reassembly. Make sure the phone is completely powered off before opening the device.

Qué necesitas

Paso 1 Back Cover

Sony Xperia XA Motherboard Replacement, Back Cover: paso 1, imagen 1 de 1

Apply heat on the back surface of the phone.
Continue to heat the device as needed throughout the replacement process.
The device can get very hot, so be careful when handling it.

Editar

Paso 2

Stick the small suction cup on the bottom half of the back surface of the phone.

Editar

Paso 3

Sony Xperia XA Motherboard Replacement: paso 3, imagen 3 de 3

With the bottom of the device facing you, lift up on the suction cup handle.
Use the plastic opening tool around all sides to pry off the back cover.

Editar

Paso 4

Sony Xperia XA Motherboard Replacement: paso 4, imagen 3 de 3

Pull the back of the phone case away from the device.
You will hear popping sounds of glue being ripped from the phone.
You will hear the sound of the back unlatching from the device.
You will need to apply adhesive or glue along the device to have maximum seal in reassembly.
RAF antenna may be attached to the back cover upon removal.

Editar

Paso 5

Apply heat to the copper RAF antenna.
This step and the following step only apply if the RAF antenna does not come off when taking the back cover off.

Editar

Paso 6

Peel back the RAF antenna.

Editar

Paso 7 Motherboard

Sony Xperia XA Motherboard Replacement, Motherboard: paso 7, imagen 1 de 2

Sony Xperia XA Motherboard Replacement, Motherboard: paso 7, imagen 2 de 2

Pry up the copper connector next to the battery with the plastic opening tool.

Editar

Paso 8

Remove the five black 4mm screws with a Phillips #00 Screwdriver.

Editar

Paso 9

Sony Xperia XA Motherboard Replacement: paso 9, imagen 3 de 3

Pry up the black camera case with the plastic opening tool and then remove the case.

Editar

Paso 10

Pop off the small connector on the right side of the motherboard with the plastic opening tool.

Editar

Paso 11

Use the spudger to take off the connector in the top right of the motherboard.

Editar

Paso 12

Sony Xperia XA Motherboard Replacement: paso 12, imagen 3 de 3

Use the flat end of the spudger to peel up the copper tab to the right of the back camera.
Peel back the tab past the connector.
Tab is stuck with adhesive.