Introducción

This guide helps users to remove a fan, which leads the user of the steps to remove and replace the fan of the laptop.

Partes

No se requieren partes.

  1. Unscrew the eleven 6 mm screws from the back panel on the bottom of laptop with the Phillips #0 screwdriver.
    • Unscrew the eleven 6 mm screws from the back panel on the bottom of laptop with the Phillips #0 screwdriver.

    • Unscrew the one 4 mm screw from the back panel on the bottom of laptop with the Phillips #0 screwdriver.

    • 6 mm screws marked in red, 4 mm marked in orange

  2. Using a plastic opening tool, pull the optical drive out of the computer by the seam.
    • Using a plastic opening tool, pull the optical drive out of the computer by the seam.

    • In reassembly, slide the optical drive back in after reapplying cover.

    • Run the opening tool along the bottom cover seam.

    • Lift the clip marked in red in order to release the back cover.

    • Lift the back cover.

    • Unplug the clip (red black yellow wires) by pulling it in an upward direction.

    • Remove two 4mm screws on the left side of the circular fan.

    • Both of these screws have a white washer attached.

    • Unscrew the four 4mm screws from the connecting copper piece. The two screws are located on either side of the copper piece.

    • The 4 mm screws won’t come out but the fan will, the screws are just to hold the fan in place.

    • Gently pull off the fan from the motherboard.

Conclusión

To reassemble your device, follow these instructions in reverse order.

qiuhong Li

Miembro Desde 04/10/18

109 Reputación

1 Guía escrita

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 31

Todo El Tiempo: 50