Partes

No se requieren partes.

Flip the computer so that the bottom is facing up.
  • Flip the computer so that the bottom is facing up.

  • Look to the long edge where the computer screen is hinged and find the "release slide". It is located at the top left corner of the square indent.

Agregar Comentario

Use your finger to slide the release to the left.
  • Use your finger to slide the release to the left.

Agregar Comentario

  • While holding the release slide with one hand, use your opposite hand to pull the battery from its slot by gently shaking the battery left and right to help slide it out.

Agregar Comentario

  • Take out the screw in the center of the computer.

Agregar Comentario

  • Flip the computer right side up.

  • Open screen so that keyboard is visible.

Agregar Comentario

  • Use a plastic opening tool to gently lift the keyboard at a corner.

  • Make sure you get below the keyboard itself and not just the keys.

  • Slide the tool around the perimeter of the keyboard and it will start to lift.

Agregar Comentario

  • Do not pull the keyboard away from the computer. There is a ribbon cord attaching the keyboard to the computer.

  • Once the keyboard has been lifted at a few edges, lift the keyboard with both hands.

Agregar Comentario

  • Locate the ribbon cord behind the keyboard.

  • Locate a brown clamp attaching the keyboard to the computer.

  • Use a plastic opening tool to lift the clamp and release the cable.

  • Now the keyboard can be pulled away entirely.

Agregar Comentario

  • Take out the screw under the keyboard.

Agregar Comentario

  • Flip computer over and remove the 6 screws.

Agregar Comentario

  • Flip computer over again and unclip the plastic cover.

  • Do not be afraid to be rough, since the cover is hard to remove.

  • Be sure to remove the case slowly and unclip any ribbon cords that are attached.

Agregar Comentario

  • Locate the hard drive disk. The hard drive disk will be covered by a shiny lid.

  • Unscrew the lid with a #00 Phillips Head Screwdriver.

  • There are 3 screws holding it in.

  • Grab the lid by one corner and pull off the lid.

Agregar Comentario

  • Find the brown clip attached to the hard disk drive on the side facing the optical disk drive.

  • Carefully pull out the brown clip with your fingers.

Agregar Comentario

  • Hold the hard disk drive on the side where the brown clip was attached and lift it upwards to pull it out.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Jenny Wang

Miembro Desde 03/04/12

92 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 5-3, Forte Spring 2012 Miembro de Cal Poly, Team 5-3, Forte Spring 2012

CPSU-FORTE-S12S5G3

5 Miembros

6 Guías creadas

Muito bom, me ajudou muito...

lordsan32 - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 3

Últimos 7 Días: 15

Últimos 30 Días: 110

Todo El Tiempo: 13,872