Introducción

How to replace the thermal paste into your laptop.

Partes

No se requieren partes.

  1. Turn the laptop upside down
    • Turn the laptop upside down

    • The battery is located on the front right side of the laptop; the opposite side from the floppy disk drive.

    Agregar Comentario

  2. As shown by the arrow, slide the plastic cover up and then pull out and downwards.
    • As shown by the arrow, slide the plastic cover up and then pull out and downwards.

    • You should now be able to pull the battery out.

    Agregar Comentario

    • Remove the four 16mm Phillips screws bordering the edge of the laptop, indicated here.

    Agregar Comentario

    • Remove the 4mm Phillips screw on the right rear side of the laptop next to the audio ports.

    • This will release the speaker grille.

    Agregar Comentario

    • Flip the computer back over and open the screen.

    Agregar Comentario

    • Slide the blue speaker grille (located above the keyboard) to the right and gently pull upward. The grille will still be connected by a white electrical strip.

    • Carefully pull out the white electrical strip.

    Agregar Comentario

    • Remove the 4mm Phillips screw in the center (located to the left of the green strip).

    • Carefully pull the green strip straight up to disconnect it.

    • The keyboard can now be removed.

    Agregar Comentario

    • Remove the two 4mm Phillips screws in the center of the computer located on each side of the copper electrical strip.

    Agregar Comentario

    • Remove the four 4mm Phillips screws around the hard drive cage.

    • WARNING: DVD drive is now loose as well.

    • Lift hard drive cage straight up.

    • Carefully disconnect the copper strip to pull out the hard drive.

    Agregar Comentario

    • With the hard drive removed, unscrew the four 6mm brass colored, Phillips screws under the hard drive cage

    • This will allow you to remove the hard drive mounting bracket

    Agregar Comentario

    • Remove the three 6mm brass colored, Phillips screws that hold the fan cage in place.

    Agregar Comentario

    • Remove the two 4mm black Phillips screws shown here.

    • Remove the 18mm silver Phillips screw shown here.

    • Now remove the silver tab.

    Agregar Comentario

    • Remove the blue and red fan power cords.

    Agregar Comentario

    • Carefully pull up and out on the metal heat sink and fan bracket.

    • You should be able to see the thermal paste.

    Agregar Comentario

    • To remove thermal paste thoroughly, put isopropyl alcohol (70% or greater) on a paper towel and wipe thermal paste off. Some force may be required.

    • Apply new thermal paste to CPU.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Sara Lillard

Miembro Desde 11/04/11

117 Reputación

8 Guías creadas

Equipo

Cal Poly, Team 12-36, Maness Spring 2011 Miembro de Cal Poly, Team 12-36, Maness Spring 2011

CPSU-MANESS-S11S12G36

4 Miembros

8 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 1

Últimos 30 Días: 6

Todo El Tiempo: 3,291