Introducción
This guide will demonstrate how to replace the speaker system of the Sony SRS-X55 portable speaker. Upon the completion of this guide the entire speaker system will be removed and replaced.
Qué necesitas
-
-
Remove the six 9 mm screws on the bottom panel using the Phillips head #2.
-
-
-
-
Insert the plastic sudger into the seam where the metal speaker cover meets the speaker body. Slide the sudger along the edge to detach the two components and set aside the cover.
-
-
-
Use the tweezers to disconnect the two cables from the input board and motherboard and finish lifting the speaker assembly from the speaker body.
on and off button ki plet+tucch plet ke parts toot gaye hai please give me new parts
-
-
-
Place the tip of the soldering iron against the wire terminals until the connection separates on its own. The three terminal locations are shown.
-
Reconnect the leads to the proper terminals. Use either of the other speakers as a reference if needed; they will have the same wire configuration.
-
For step-by-step instructions on soldering check out this link Cómo soldar y desoldar conexiones.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
4 personas más completaron esta guía.
6 comentarios
Hello, Thanks for your tuto … Please can you help me to buy a new central loudspeaker … I only found "already used parts" on eBay an would like to buy a new "not used" part ? Thanks in advance for your answer
hi im in the same situation as Pascal I cant find where to buy the 10W bass speaker online.
Steve Chaney
Hi Steve,
I have the same problem. Did you find some 10w bass speaker?
Sven from germany
Tuchplet is damaging and new tuchplet ripleys
Hello I hope you can help. My SRS X55 fell but worked perfectly. Sound perfect. But when the battery weakend I noticed that it would not charge. Of course I have played with the charger cable and various outlets. What is suggested?