Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the battery pack door by moving the slider to "OPEN".
-
Remove the 3.25 mm silver screw inside the battery pack with a Phillips screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 3.25 mm exterior screw with a Phillips screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the spudger to raise the corner of the case from the camera.
-
One component of the front case should now be separate from the camera.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three (3.5 mm) screws from the bottom of the camera with the Phillips screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the HDMI port, and remove the the two (3.5 mm) Phillips screws exposed on that side.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 4mm screws from the interior of the battery pack, and one 3.5mm screw from beside it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Looking at the bottom of the camera, use the spudger to lift the rear case away from the camera body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the spudger again, carefully pry from the top of the camera to remove the back frame.
-
The back frame is fragile, so use the spudger gently.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The back case should now be removed and look like this.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.