Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y herramientas

Introducción

The removal of the main navigation button involves removing the rear casing and carefully prying off the button as to not damage the sensitive components.

Partes

No se especificaron partes.

  1. Remove the three (3.5 mm) screws from the bottom of the camera with the Phillips screwdriver.
    • Remove the three (3.5 mm) screws from the bottom of the camera with the Phillips screwdriver.

  2. Open the HDMI port, and remove the the two (3.5 mm) Phillips screws exposed on that side.
    • Open the HDMI port, and remove the the two (3.5 mm) Phillips screws exposed on that side.

  3. Remove the two 4mm screws from the interior of the battery pack, and one 3.5mm screw from beside it.
    • Remove the two 4mm screws from the interior of the battery pack, and one 3.5mm screw from beside it.

  4. Kits para Nintendo Switch

    Una solución rápida para volver al juego

    Comprar kits de Switch

    Kits para Nintendo Switch

    Una solución rápida para volver al juego

    Comprar kits de Switch
  5. Looking at the bottom of the camera, use the spudger to lift the rear case away from the camera body.
    • Looking at the bottom of the camera, use the spudger to lift the rear case away from the camera body.

  6. Using the spudger again, carefully pry from the top of the camera to remove the back frame. The back frame is fragile, so use the spudger gently.
    • Using the spudger again, carefully pry from the top of the camera to remove the back frame.

    • The back frame is fragile, so use the spudger gently.

  7. The back case should now be removed and look like this.
    • The back case should now be removed and look like this.

  8. Use spudger to pull the lead out from its housing.
    • Use spudger to pull the lead out from its housing.

  9. Squeeze the lead with the tweezers and hold the lead teeth tightly with your fingers. Pull straight out to disconnect. Squeeze the lead with the tweezers and hold the lead teeth tightly with your fingers. Pull straight out to disconnect.
    • Squeeze the lead with the tweezers and hold the lead teeth tightly with your fingers. Pull straight out to disconnect.

  10. The navigation button component should now be separate and able to be replaced with new component. The camera and navigation button should appear as shown. The navigation button component should now be separate and able to be replaced with new component. The camera and navigation button should appear as shown.
    • The navigation button component should now be separate and able to be replaced with new component. The camera and navigation button should appear as shown.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Emily Trujillo

Miembro Desde 08/04/14

1,102 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 8-9, Regan Spring 2014 Miembro de Cal Poly, Team 8-9, Regan Spring 2014

CPSU-REGAN-S14S8G9

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 5

Ultimos 30 días: 23

Todo El Tiempo: 2,802