Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Find the arrow on the battery cover on the back of the device.
-
While pressing down on the arrow, slide the cover towards the bottom of the recorder until it clicks.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the battery cover by first tilting it so it is at a right angle with the rest of the device.
-
Next, twist it to the side as shown in the second picture. The lid should simply snap off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a #00 Phillips head screwdriver to remove the four (1.7x16 mm) screws from the back case.
-
Next, use the same screwdriver to unscrew the (1.7X5 mm) screw, which is located inside the battery compartment.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to push in the two tabs located on the bottom of the device.
-
It works best to push the tabs at an upward angle (towards the top of the battery compartment)
-
It may take a decent amount of force in order to push in the tabs.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With a firm grip on the larger half, remove the back cover by lifting first on the battery area.
-
The back cover should lift cleanly off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The speaker is the large gold circular piece attached under where the batteries would normally be.
-
It is connected to the device with two black wires that run along one side of the motherboard, as shown on the top of the picture.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Depending on the replacement speaker you have, there are two places you can desolder the wire.
-
If your replacement speaker has a wire already attached to it, desolder the old wire from where it connects to the motherboard.
-
If the replacement speaker has no wire, desolder the old wire where it connects to the broken speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unscrew the 2 Phillips head screws (2x2.5 mm) around the edge of the speaker with a #00 Phillips screwdriver.
-
Use a pair of tweezers to remove the black tape on the speaker. Put the tape on the back of the new speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Now that the speaker is detached from the device, simply tilt the device over and let the speaker fall out.
-
Equipo
Cal Poly, Team 10-34, Amido Winter 2012 Miembro de Cal Poly, Team 10-34, Amido Winter 2012
CPSU-AMIDO-W12S10G34
4 Miembros
7 Guías creadas
