Sony Handycam DCR-SR68 LCD Screen Replacement

Introducción

Can't view your pictures anymore after dropping your camera, and breaking the screen ? This guide will help you replace your LCD screen, so you can enjoy your camera once again.

Qué necesitas

Paso 1 HDD

Sony Handycam DCR-SR68 LCD Screen Replacement, HDD: paso 1, imagen 1 de 1

Herramienta utilizada en este paso:

Anti-Static Wrist Strap

$7.95

Comprar

Wash and dry your hands, then put on a properly grounded anti-static wrist strap, before handling internal electronic components. To ground the wrist strap, attach it to the metal chassis of a plugged-in three prong power supply, of a computer for example.
Unfasten the hand strap.
Remove the battery.

Traducir

Paso 2

Place device on left side with front lens facing right.
Using a JIS size #00 precision Phillips screwdriver, unscrew the left middle 3mm Phillips screw.
Open the "DC IN" plastic tab (Second 3mm Phillips screw is revealed).
Unscrew the second 3mm Phillips screw.

Traducir

Paso 3

Turn device over onto its top with the front lens facing right.
Unscrew the top left and top right 3mm Philips screws.
The right side case panel is now unfastened (the case panel facing up in the photo).

Traducir

Paso 4

Remove the right side case panel by pulling up.
The Hard Drive (HDD) is now revealed.

Traducir

Paso 5

Sony Handycam DCR-SR68 LCD Screen Replacement: paso 5, imagen 3 de 3

Using your fingers, lift the HDD from its right end, pivoting on its left end.
The HDD ribbon wire is now exposed.

Traducir

Paso 6

While securely holding the HDD in your left hand, use the soft pad of your right hand fingers to gently pull the ribbon wire out of its socket, toward your right.
The HDD is now free from the device.
Replace HDD.

Traducir

Paso 7 LCD Screen

Sony Handycam DCR-SR68 LCD Screen Replacement, LCD Screen: paso 7, imagen 1 de 1

Follow steps steps 1-6 on HDD removal.
Once completed set aside HDD.

Traducir

Paso 8

Remove the A/V tab

Traducir

Paso 9

Remove the right and middle bottom 3mm Philips screws from the bottom of the device.
Then remove panel.

Traducir

Paso 10

On the left side of the device, remove all visible 3mm Philips screws.

Traducir

Paso 11

On the right side of the device, remove the two black 3mm Philips screws.
The grey tray is now loose.
Remove the grey tray by lifting out and away.

Traducir

Paso 12

Using the black spudger, carefully open the little black clasp on the large ribbon wire port.
These clasps are known to be fragile.
On reassembly, this wire and clasp can be troublesome to reinstall.