Saltar al contenido principal

Sony Ericsson W810I Charger Adapter Replacement

Guía Archivada
Esta guía se mantiene únicamente para fines históricos. Utiliza la última versión de la guía para llevar a cabo tu reparación.

Qué necesitas

  1. Sony Ericsson W810I Charger Adapter Replacement, Charger Adapter: paso 1, imagen 1 de 1
    • Power the phone off.

    • Press down firmly against the icon on the lower rear panel with your thumb.

    • Slide the panel down to remove it.

  2. Sony Ericsson W810I Charger Adapter Replacement: paso 2, imagen 1 de 2 Sony Ericsson W810I Charger Adapter Replacement: paso 2, imagen 2 de 2
    • Lift the battery and pull it out.

    • Remove the SIM card too if you have one.

  3. Sony Ericsson W810I Charger Adapter Replacement: paso 3, imagen 1 de 2 Sony Ericsson W810I Charger Adapter Replacement: paso 3, imagen 2 de 2
    • Remove the following screws:

    • Two T7 Torx screws

    • Two Phillips #00 screws

  4. Sony Ericsson W810I Charger Adapter Replacement: paso 4, imagen 1 de 2 Sony Ericsson W810I Charger Adapter Replacement: paso 4, imagen 2 de 2
    • Use an opening tool to remove the camera faceplate.

    • Be careful to not bend the camera faceplate when removing it.

  5. Sony Ericsson W810I Charger Adapter Replacement: paso 5, imagen 1 de 3 Sony Ericsson W810I Charger Adapter Replacement: paso 5, imagen 2 de 3 Sony Ericsson W810I Charger Adapter Replacement: paso 5, imagen 3 de 3
    • Flip the phone over and use an opening tool to pry off the number pad.

    • Separate the keypad from the motherboard.

  6. Sony Ericsson W810I Charger Adapter Replacement: paso 6, imagen 1 de 1
    • Remove two T6 Torx screws that secure the motherboard.

    • Use an opening tool to remove the motherboard. Pay attention to cables on the motherboard.

    • Do not pry too hard on the motherboard, as it can break under too much force.

  7. Sony Ericsson W810I Charger Adapter Replacement: paso 7, imagen 1 de 1
    • Pull off charger adapter and remove it.

    • Pull evenly on the full width of the cable so that no individual wires are overly strained.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Ben Micucci

Miembro Desde 10/14/11

186 Reputación

5 Guías creadas

Equipo

James Madison, Team 2-2, Allen Fall 2011 Miembro de James Madison, Team 2-2, Allen Fall 2011

JMU-ALLEN-F11S2G2

2 Miembros

10 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 1,607