Introducción

This guide will assist you in removing the speaker from your Sony Ericsson T68i.

Partes

No se requieren partes.

Remove the battery from the back.
  • Remove the battery from the back.

Agregar Comentario

Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips.
  • Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips.

  • Do not bend it too far down, or else you risk breaking the two bottom clips.

Agregar Comentario

  • Unscrew all four Torx T6 screws.

  • Keep in a safe place.

Agregar Comentario

  • After removing the screws, the two halves will separate. If not, then pry them gently apart.

Agregar Comentario

  • Remove the circuit board and screen from the device.

  • Use your T6 to remove the 4 screws.

Agregar Comentario

  • Remove the board and screen.

Agregar Comentario

  • Carefully remove the plastic clips holding the screen on the board.

Agregar Comentario

  • Gently pry it out the speaker located in the screen housing with a small screwdriver or similar tool.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Tim Dascomb

Miembro Desde 13/04/10

123 Reputación

13 Guías creadas

Equipo

Cal Poly, Team 26-34, Regan Spring 2010 Miembro de Cal Poly, Team 26-34, Regan Spring 2010

CPSU-REGAN-S10S26G34

4 Miembros

13 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 2,097