Introducción

This guide will assist you in removing the microphone from your Sony Ericsson T68i.

Partes

No se requieren partes.

Remove the battery from the back.
  • Remove the battery from the back.

Agregar Comentario

Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips.
  • Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips.

  • Do not bend it too far down, or else you risk breaking the two bottom clips.

Agregar Comentario

  • Unscrew all four Torx T6 screws.

  • Keep in a safe place.

Agregar Comentario

  • After removing the screws, the two halves will separate. If not, then pry them gently apart.

Agregar Comentario

  • Next remove the circuit board and screen from the device.

  • Use your T6 to remove the 4 screws holding the cover on.

Agregar Comentario

  • The board and screen should just pop out at this point.

Agregar Comentario

  • The microphone at the bottom of the rear housing can be levered out using a small screwdriver or any similar tool.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Tim Dascomb

Miembro Desde 13/04/10

123 Reputación

13 Guías creadas

Equipo

Cal Poly, Team 26-34, Regan Spring 2010 Miembro de Cal Poly, Team 26-34, Regan Spring 2010

CPSU-REGAN-S10S26G34

4 Miembros

13 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 2,010