Introducción

Removing the processing board allows you to access other components like the DVD drive and remaining circuit boards.

Partes

No se requieren partes.

Remove the five #1 Phillips screws (black, 3/16") attaching the cover to the DVD player. One 3/16" screw on the right side of the DVD player.
  • Remove the five #1 Phillips screws (black, 3/16") attaching the cover to the DVD player.

    • One 3/16" screw on the right side of the DVD player.

    • One 3/16" screw on the left side of the DVD player (directly opposite of other screw).

    • Three 3/16" screws on the back of the DVD player.

Agregar Comentario

Slide the cover away from the front of the DVD player until it is off. Slide the cover away from the front of the DVD player until it is off.
  • Slide the cover away from the front of the DVD player until it is off.

Agregar Comentario

Remove the blue tape from the processing board by gently pulling upward.
  • Remove the blue tape from the processing board by gently pulling upward.

Agregar Comentario

Use the tweezers to remove the four sets of wires connected to the processing board.  Start with the cord located in front of the row of three cords. The wires may be difficult to remove.  Wiggling them while lifting them up may help remove them.
  • Use the tweezers to remove the four sets of wires connected to the processing board. Start with the cord located in front of the row of three cords.

  • The wires may be difficult to remove. Wiggling them while lifting them up may help remove them.

Agregar Comentario

Handle the processing board with care.  It is fragile.
  • Handle the processing board with care. It is fragile.

  • Unscrew the two #1 Phillips screws (silver, 3/16") located on the two edge corners of the processing board.

Agregar Comentario

Orient the DVD player so that you are facing the video and audio jacks.
  • Orient the DVD player so that you are facing the video and audio jacks.

  • Unscrew the two #1 Phillips screws (silver, 3/16") located on the outside of the DVD player

  • The processing board is now free to be removed and replaced.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Brian Hua

Miembro Desde 11/01/13

58 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 5-17, Forte Winter 2013 Miembro de Cal Poly, Team 5-17, Forte Winter 2013

CPSU-FORTE-W13S5G17

5 Miembros

6 Guías creadas

I have Sony DVD player dvp at510p. After switching it runs then automatic Power go down while running it's process ic get hotter and hotter what's the right solutions plz help me

Dhiraj Vasave - Contestar

SO my DVD player run 5to 6 minutes then automatic stop all power goes to less

Dhiraj Vasave - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 25

Todo El Tiempo: 1,214