Repara tus cosas Comunidad Tienda

Sony Cyber-shot DSC-W800 LCD Screen Replacement

Introducción

Some things to consider before you work on the Sony Cyber-shot DSC W800 to replace the LCD Screen:

  • The LCD Screen is an integral part of the device and any improper handling can cause issues in other parts of the camera.
  • Be cautious when removing ribbon wires.
  • Be sure to keep track of all pieces that are taken apart.

Qué necesitas

  1. Sony Cyber-shot DSC-W800 LCD Screen Replacement, Button Board: paso 1, imagen 1 de 3 Sony Cyber-shot DSC-W800 LCD Screen Replacement, Button Board: paso 1, imagen 2 de 3 Sony Cyber-shot DSC-W800 LCD Screen Replacement, Button Board: paso 1, imagen 3 de 3

    • Remove the five 4.0 mm Phillips #000 screws on the back panel.

    Editar

  2. Sony Cyber-shot DSC-W800 LCD Screen Replacement: paso 2, imagen 1 de 2 Sony Cyber-shot DSC-W800 LCD Screen Replacement: paso 2, imagen 2 de 2

    • Using the Spudger, remove the back panel from the device.

    • The loose piece circled in the picture will most likely fall off the camera housing.

    Editar

  4. Sony Cyber-shot DSC-W800 LCD Screen Replacement: paso 3, imagen 1 de 3 Sony Cyber-shot DSC-W800 LCD Screen Replacement: paso 3, imagen 2 de 3 Sony Cyber-shot DSC-W800 LCD Screen Replacement: paso 3, imagen 3 de 3

    • Remove the two 2.15mm Phillips #000 screws from the circuit board.

    • Gently pull on the ribbon wire from ZIF connector with the tweezers to remove the button board.

    • Ribbon wires can easily be damaged.

    Editar

  5. Sony Cyber-shot DSC-W800 LCD Screen Replacement, LCD Screen: paso 4, imagen 1 de 1

    • Remove the four 3.75 mm Phillips #000 screws from the LCD back panel.

    Editar

  6. Sony Cyber-shot DSC-W800 LCD Screen Replacement: paso 5, imagen 1 de 1

    • Lift the back panel and separate the LCD Screen by prying it up.

    • Remove the back panel.

    Editar

  7. Sony Cyber-shot DSC-W800 LCD Screen Replacement: paso 6, imagen 1 de 2 Sony Cyber-shot DSC-W800 LCD Screen Replacement: paso 6, imagen 2 de 2

    • Gently pull on the ribbon wire disconnecting from the ZIF connector (connecting the LCD screen to the motherboard) with the tweezers.

    • Ribbon wires can be easily damaged.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Autor

con 3 otros colaboradores

Thomas Campo

Miembro Desde 02/09/16

788 Reputación

4 Guías creadas

Insignias: 16

+ 13 más insignias

Equipo

USF Tampa, Team 17-5, Blackwell Winter 2016 Miembro de USF Tampa, Team 17-5, Blackwell Winter 2016

USFT-BLACKWELL-W16S17G5

5 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 5

Ultimos 30 días: 16

Todo El Tiempo: 2,442