Introducción

Is your LCD screen acting strange? Replacing the CCD Sensor Module is a straight forward task that will increase the clarity of your screen.

Partes

No se requieren partes.

  1. Locate the battery door at the bottom of the camera.
    • Locate the battery door at the bottom of the camera.

    • Press down on the door and slide it back. The door will pop open.

    Agregar Comentario

  2. Remove the battery from the door that you opened in the previous step.
    • Remove the battery from the door that you opened in the previous step.

    Agregar Comentario

    • There are two screws on the left and right sides of the camera, and two screws on the bottom.

    • Use a PH00 screwdriver and remove the six 2.9mm screws.

    Agregar Comentario

    • Use hands to gently pry the front casing away from the camera.

    Agregar Comentario

    • Use the tip of a spudger to flip up the tab on the ZIF connector securing the motherboard ribbon cable.

    • The second picture shows what these tabs look like in their open positions.

    Agregar Comentario

    • Grasp the CCD Sensor Module and remove it.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

iDeleted

Miembro Desde 07/07/10

2,101 Reputación

39 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 10

Todo El Tiempo: 11,520