Partes

No se requieren partes.

Slide the battery latch down the side of the camera with your hands.
  • Slide the battery latch down the side of the camera with your hands.

  • The latch will automatically pop open.

Agregar Comentario

Unlatch the clip over the battery.
  • Unlatch the clip over the battery.

  • The battery will partially pop out.

Agregar Comentario

  • Remove the battery from the camera.

Agregar Comentario

  • Remove the four 3.0mm Phillips #000 screws on the top of the camera with the phillips screwdriver.

  • Remove the additional four 3.0mm Phillips #000 screws on the bottom of the camera.

Agregar Comentario

  • Once the screws are removed, slowly remove the back casing from the rest of the camera.

Agregar Comentario

  • Then, pull the front case away from the rest of the camera.

Agregar Comentario

  • After the casing is removed, the camera should look as shown.

Agregar Comentario

  • Dislodge the round casing from the lens.

  • Pull it away from the rest of the camera.

Agregar Comentario

  • Unscrew the two 4.0mm Phillips #000 screws from the display.

Agregar Comentario

  • Pull the two ribbon cables out of their slots on the back circuit board.

Agregar Comentario

  • Remove the three 4.0mm Phillips #000 screws holding the back panel in place.

Agregar Comentario

  • Work the back panel out from under the small grey clip.

  • Slide the back panel off of the camera by dislodging it from the remaining clips.

  • Below is a flat, orange cable connecting the lens to the motherboard.

  • Be careful not to bend the back plate during this process.

Agregar Comentario

  • Turn the camera over so that you can see the front of the lens.

  • Two connectors link the lens to the motherboard.

  • Gently bring the lens away from the camera.

Agregar Comentario

  • Using the flat end of the plastic spudger tool, flip up the black tabs on the connectors.

  • Be careful not to exert too much force, as the connectors are delicate.

Agregar Comentario

  • Gently pull out the cables and move the lens away from the rest of the camera.

  • You should now have two distinct, separate components.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Sean Sayles

Miembro Desde 09/05/12

7 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 17-25, Amido Spring 2012 Miembro de Cal Poly, Team 17-25, Amido Spring 2012

CPSU-AMIDO-S12S17G25

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 1,050