Saltar al contenido principal

Introducción

The LCD should be checked if the screen is blank or broken.

  1. Open the battery compartment and remove the batteries.
    • Open the battery compartment and remove the batteries.

    • Remove all of the visible screws on the outside of the case.

    • There should be three of them that are all easily located.

  2. Open the memory card compartment.
    • Open the memory card compartment.

    • Remove the screw next to the memory card slot.

  3. Pull apart the front and back cover pieces carefully.
    • Pull apart the front and back cover pieces carefully.

    • The front cover should come completely free with little effort.

    • The back cover will still be attached to the circuit board.

  4. Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
    • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

    • The circuitry will still be connected to the back case by ribbon cables.

  5. Open the case as shown.
    • Open the case as shown.

  6. Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora

    Baterías para ordenadores portátiles

    Un pequeño arreglo para un gran resultado.

    Comprar Ahora
  7. Unclip the clip holding the ribbon cable in.
    • Unclip the clip holding the ribbon cable in.

    • Other ribbon cables might not have a clips.

  8. Pull the ribbon cable out.
    • Pull the ribbon cable out.

  9. Unclip the ribbon cable shown the in picture.
    • Unclip the ribbon cable shown the in picture.

    • Some ribbon cables do not have a clip holding them in.

  10. Pull the ribbon cable out.
    • Pull the ribbon cable out.

  11. Remove 7 Screws to remove plate and expose LCD screen.
    • Remove 7 Screws to remove plate and expose LCD screen.

  12. Remove LCD plate to expose LCD components and ribbon cables
    • Remove LCD plate to expose LCD components and ribbon cables

  13. Check connection of LCD to cables
    • Check connection of LCD to cables

    • If cables are intact, disconnect cables and replace LCD with new part

  14. Repeat steps in reverse order to reassemble the camera
    • Repeat steps in reverse order to reassemble the camera

Conclusión

To reassemble your device, follow these instructions in reverse order.

Mark

Miembro Desde 11/01/11

13 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 3-43, Regan Winter 2011 Miembro de Cal Poly, Team 3-43, Regan Winter 2011

CPSU-REGAN-W11S3G43

4 Miembros

10 Guías creadas

I don’t know the cause of my camera not turning on.

Smgmc64 Productions - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 2

Todo El Tiempo: 2,295