Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
First, place the device with the screen side facing down. Remove the 2 screws from the thumb dial panel located on the upper right hand side.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the screw directly above the thumb dial panel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the screw from thumb dial panel on the right handed side of the device.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove 1 screw from the lower left side of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
On the bottom of the device, remove both the left and right screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the thumb dial panel by sliding it away from the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the back panel exposing the inside of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Follow ribbon wire to locate where it plugs into the board. The plug is a flat black square.
-