Partes

No se requieren partes.

Remove two screws from the thumb dial panel on the back of the device
  • Remove two screws from the thumb dial panel on the back of the device

Agregar Comentario

Remove 1 screw from upper right corner on the back of the device.
  • Remove 1 screw from upper right corner on the back of the device.

Agregar Comentario

  • Romove 1 screw from thumb dial panel on the righ side of the device.

Agregar Comentario

  • Remove screw from lower right side of the device.

Agregar Comentario

  • Remove 1 screw from the lower left side of the device.

Agregar Comentario

  • Romove 2 screws from the bottom of the device.

Agregar Comentario

  • Remove the thumb dial panel by sliding it away from the device. (note: you can do this step earlier after you remove all screws from thumb drive panel)

Agregar Comentario

  • Remove the back panel exposing the inside of the device.

Agregar Comentario

  • Remove 1 screw located on board below battery.

Agregar Comentario

  • Unplug male battery plug on the battery wire from the female battery plug on the board.

Agregar Comentario

  • remove the battery from the device by sliding it out of the side of the device

Agregar Comentario

  • slide new battery under the board from the side of the device.

Agregar Comentario

  • Plug battery back into board.

Agregar Comentario

  • Place screw back into board.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Rob

Miembro Desde 04/10/11

1 Reputación

2 Guías creadas

Equipo

UW Stout, Team 5-6, Zhou Fall 2011 Miembro de UW Stout, Team 5-6, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G6

4 Miembros

2 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 1,447