Saltar al contenido principal

Snowboard Binding Replacement

Qué necesitas

  1. Snowboard Binding Replacement, Binding: paso 1, imagen 1 de 3 Snowboard Binding Replacement, Binding: paso 1, imagen 2 de 3 Snowboard Binding Replacement, Binding: paso 1, imagen 3 de 3
    • Release the binding straps by lifting up on the buckle and pulling towards the direction of the end of the ladder.

    • Not all binding straps will release the same way. If you are having trouble releasing your binding straps, please refer to your owner's manual.

  2. Snowboard Binding Replacement: paso 2, imagen 1 de 2 Snowboard Binding Replacement: paso 2, imagen 2 de 2
    • Move the straps and the highback plate out of the way in order to have clear access to the foot pad screw.

    • The highback plate is the vertical support plate located on the heel side of the binding.

  3. Snowboard Binding Replacement: paso 3, imagen 1 de 2 Snowboard Binding Replacement: paso 3, imagen 2 de 2
    • Use a #2 Phillips screwdriver to remove the panhead, 10mm wide, M4 x 12mm screw located in the middle of the foot pad.

  4. Snowboard Binding Replacement: paso 4, imagen 1 de 3 Snowboard Binding Replacement: paso 4, imagen 2 de 3 Snowboard Binding Replacement: paso 4, imagen 3 de 3
    • Use a #2 Phillips screwdriver to remove the four ovalhead M6 x 12mm screws that attach the base plate of the binding to the board.

    • Lift or slide the binding off the board and set the screws aside.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Loren Sunding

Miembro Desde 01/14/14

118 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 17-4, Forte Winter 2014 Miembro de Cal Poly, Team 17-4, Forte Winter 2014

CPSU-FORTE-W14S17G4

5 Miembros

9 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 9

Ultimos 30 días: 95

Todo El Tiempo: 13,382