Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Many vacuum cleaners have a separate pet hair and power brush head. The roller brush of the head can easily break due to wear and tear. Use this guide to replace the internal roller brush in the power brush head of your Shark vacuum cleaner.

  1. This Shark model brush head consists of 7 parts: a base frame, a gear, a roller brush, two side screws, a plastic round band, and a top frame of the head. Push the grey button on the back panel to open up the brush head.
    • This Shark model brush head consists of 7 parts: a base frame, a gear, a roller brush, two side screws, a plastic round band, and a top frame of the head.

    • Push the grey button on the back panel to open up the brush head.

  2. Take the purple gear out of the brush head body. Take the purple gear out of the brush head body.
    • Take the purple gear out of the brush head body.

  3. SALTEA LA ACTUALIZACIÓN

    Ahorra reparando con un kit todo en uno.

    Compra Kits de Reparación

    SALTEA LA ACTUALIZACIÓN

    Ahorra reparando con un kit todo en uno.

    Compra Kits de Reparación
  4. Pull out the roller brush from the brush head. Take out the black plastic band.
    • Pull out the roller brush from the brush head.

    • Take out the black plastic band.

    • The black band is an important component and will be needed for reassembly so keep it carefully.

  5. Pull out the side screws from the right and left side of the roller brush.
    • Pull out the side screws from the right and left side of the roller brush.

    • There are two screws, one on each side.

  6. Take the new roller brush and fit the two grey screws/fittings on either side of the roller brush  until they are secure. Take the new roller brush and fit the two grey screws/fittings on either side of the roller brush  until they are secure. Take the new roller brush and fit the two grey screws/fittings on either side of the roller brush  until they are secure.
    • Take the new roller brush and fit the two grey screws/fittings on either side of the roller brush until they are secure.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Roshni Sachar

Miembro Desde 19/03/16

184 Reputación

1 Guía escrita

Equipo

Cat hair will jam up in the small gap between the gear and the bushing on the turbine and will cause enough friction to stop the turbine. I used a needle to dig out the hair and it solved the problem.

hvabrams - Contestar

very clear and concise. took me 5 minutes with your instructions - couldn’t find anything like this on the shark site.

tigersfoot - Contestar

I need to put back all parts , don’t know where to start, can u explain step by step how to put them back please . Thank you

paolodigiacomo23 - Contestar

Where can I purchase one of the side screw/fittings?

Renee Mills - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 16

Ultimos 7 días: 122

Ultimos 30 días: 476

Todo El Tiempo: 22,078