Repara tus cosas Comunidad Tienda

Shark Ultimate Professional Reservoir Replacement

Qué necesitas

  1. Shark Ultimate Professional Reservoir Replacement, Reservoir: paso 1, imagen 1 de 3 Shark Ultimate Professional Reservoir Replacement, Reservoir: paso 1, imagen 2 de 3 Shark Ultimate Professional Reservoir Replacement, Reservoir: paso 1, imagen 3 de 3

    • Remove the two screws at the back of the iron.

    • Remove the back cover piece.

    • Make sure iron is unplugged and cooled off.

    Editar

  2. Shark Ultimate Professional Reservoir Replacement: paso 2, imagen 1 de 2 Shark Ultimate Professional Reservoir Replacement: paso 2, imagen 2 de 2

    • Remove the two screws holding the white clamp to the iron.

    • Remove the two screws holding the black wires to the body of the iron.

    • Removing the left black wire will also free the red wire, attached by the same screw.

    Editar

  4. Shark Ultimate Professional Reservoir Replacement: paso 3, imagen 1 de 1

    • Pull the split end of the power cord upward through the ball joint of the iron.

    • Set aside power cord.

    Editar

  5. Shark Ultimate Professional Reservoir Replacement: paso 4, imagen 1 de 3 Shark Ultimate Professional Reservoir Replacement: paso 4, imagen 2 de 3 Shark Ultimate Professional Reservoir Replacement: paso 4, imagen 3 de 3

    • Remove remaining screws that hold a wire on the bottom (brown and blue).

    • Unscrew from left to right.

    • Unclip the black adapter piece on the bottom right.

    • Wires order (from left to right): Brown, Blue, Red, Black

    Editar

  6. Shark Ultimate Professional Reservoir Replacement: paso 5, imagen 1 de 2 Shark Ultimate Professional Reservoir Replacement: paso 5, imagen 2 de 2

    • Remove two screws (left and right) affixed to circuit board.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Autor

con 1 otro colaborador

Drew Carff

Miembro Desde 10/23/17

868 Reputación

5 Guías creadas

Insignias: 14

+ 11 más insignias

Equipo

USF Tampa, Team S1-G4, Leahy Fall 2017 Miembro de USF Tampa, Team S1-G4, Leahy Fall 2017

USFT-LEAHY-F17S1G4

3 Miembros

10 Guías creadas

3 comentarios

i am trying to replace the thermal cutoff but can’s remember the wire inside how to replace

primrose33166 - Contestar

I have a constant leak in the vertical position - long after the iron is cold. The repair presented is well done. However it stopped short and doesn't get to the reservoir - thanks

Dalmacca-Hame - Contestar

Then WHAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAT?

Muhammad Ahmad - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 7

Ultimos 30 días: 18

Todo El Tiempo: 2,135