Shark Rotator Powered Lift-Away Speed Hose Replacement

Escrito Por: Sujey Ruano (y 3 de otros participantes)

Comentarios: 2
Favoritos: 0
Terminaciones: 1

Shark Rotator Powered Lift-Away Speed Hose Replacement

Dificultad

Difícil

Pasos

Tiempo Requerido

15 - 30 minutos

Introducción

A damaged hose will not allow the vacuum to function properly. This guide will assist in the replacement process. The hose is electrically attached to the other components of the vacuum. Removal of the hose will require electrical components.

Herramientas

Comprar estas herramientas

Partes

No se requieren partes.

Paso 1 Hose

Press down on the hose release button and pull away from the vacuum

Press down on the hose release button and pull away from the vacuum

Traducir

Paso 2

Press down on the wand release button and remove the wand from the vacuum.

Press down on the wand release button and remove the wand from the vacuum.

Traducir

Paso 3

Press down on the handle release button and pull the wand away from the vacuum.

Press down on the handle release button and pull the wand away from the vacuum.

Traducir

Paso 4

Remove five 13.4 mm screws from the handle with a T20 Torx bit.

Remove five 13.4 mm screws from the handle with a T20 Torx bit.

Traducir

Paso 5

Using a T20 Torx bit, remove the two 13.4 mm screws from the front of the nozzle.

Using a T20 Torx bit, remove the two 13.4 mm screws from the front of the nozzle.

Traducir

Paso 6

Remove the neck ring by placing a spudger under the brace and lifting outwards.

It may be helpful to use a heat gun on the brace and then attempt removing with a spudger.

Remove the neck ring by placing a spudger under the brace and lifting outwards.
It may be helpful to use a heat gun on the brace and then attempt removing with a spudger.

Traducir

Paso 7

Run the spudger along the center seam of the handle, pulling it apart as you go.

Run the spudger along the center seam of the handle, pulling it apart as you go.

Traducir

Paso 8

Remove the single 13.4 mm screw at the bottom of the handle grip and then lift the grip with a spudger.

Remove the single 13.4 mm screw at the bottom of the handle grip and then lift the grip with a spudger.

Traducir

Paso 9

Remove the single 13.4 mm screw from underneath the handle grip. You are then able to open the handle using a spudger and pulling the pieces apart.

Remove the single 13.4 mm screw from underneath the handle grip. You are then able to open the handle using a spudger and pulling the pieces apart.

Traducir

Paso 10

Using two spudgers, unclip the hose from the handle.

Using two spudgers, unclip the hose from the handle.

Traducir

Paso 11

Use wire cutters to clip the white and black wire that connect the hose to the handle.

Soldering or wire connectors are necessary for reassembly.

Use wire cutters to clip the white and black wire that connect the hose to the handle.
Soldering or wire connectors are necessary for reassembly.
Any time you are dealing with electrical components, be sure the device is unplugged.