Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Press the mop head release button to remove it from the steam mop body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 10mm screws holding the joint assembly to the mop head with your Phillips #2 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two plastic hinge covers by pulling the hinges out of the joint and sliding the covers off.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Stretch joint assembly forward to expose two 11mm Phillips #2 screws on either side of the steam tube.
-
Remove both screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift joint assembly out of hinge socket and pull upward with mild force to disconnect steam nozzle.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
2 comentarios
This was fantastic. Only place I found on how to disassemble mop head. If i were you, I would go a little further and explain how to clean the nozzle. Use a paper clip or 20 gauge wire to push build up out. If that does not work use a small drill bit ( be careful to drill straight or you could damage the wall or jacket . This worked for me. Saved me $30. Had a problem locating this sight. Maybe some way to make it easier to locate would help. Thanks for your posting.
Do you know if I can soak this part in clr? I can't seem to clean it well enough.