Repara tus cosas Comunidad Tienda

Shark Professional Steam Pocket Mop Steam Nozzle Replacement

Introducción

If your mop is not emitting steam then replacing the nozzle may help. Before doing any disassembly on your Shark Professional Steam Pocket Mop, make sure to unplug the mop and empty the water tank for your safety.

Qué necesitas

  1. Shark Professional Steam Pocket Mop Steam Nozzle Replacement, Steam Nozzle: paso 1, imagen 1 de 1

    • Press the mop head release button to remove it from the steam mop body.

    Traducir

  2. Shark Professional Steam Pocket Mop Steam Nozzle Replacement: paso 2, imagen 1 de 1

    • Remove the four 10mm screws holding the joint assembly to the mop head with your Phillips #2 screwdriver.

    Traducir

  3. Shark Professional Steam Pocket Mop Steam Nozzle Replacement: paso 3, imagen 1 de 1

    • Remove the two plastic hinge covers by pulling the hinges out of the joint and sliding the covers off.

    Traducir

  5. Shark Professional Steam Pocket Mop Steam Nozzle Replacement: paso 4, imagen 1 de 1

    • Stretch joint assembly forward to expose two 11mm Phillips #2 screws on either side of the steam tube.

    • Remove both screws.

    Traducir

  6. Shark Professional Steam Pocket Mop Steam Nozzle Replacement: paso 5, imagen 1 de 1

    • Lift joint assembly out of hinge socket and pull upward with mild force to disconnect steam nozzle.

    Traducir

  7. Shark Professional Steam Pocket Mop Steam Nozzle Replacement: paso 6, imagen 1 de 1

    • Use needle nose pliers to compress metal clamp .

    Traducir

  8. Shark Professional Steam Pocket Mop Steam Nozzle Replacement: paso 7, imagen 1 de 1

    • Pull the nozzle out of the tube.

    Traducir

    Where can I get a new rubber hose? The one I have broke in half.

    Akiva Israel - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 3 otros colaboradores

Michael Raymond

Miembro Desde 02/12/18

154 Reputación

1 Guía escrita

Insignias: 4

+1 mas insignia

Equipo

USF Tampa, Team S15-G1, Boczar Spring 2018 Miembro de USF Tampa, Team S15-G1, Boczar Spring 2018

USFT-BOCZAR-S18S15G1

4 Miembros

14 Guías creadas

2 comentarios

This was fantastic. Only place I found on how to disassemble mop head. If i were you, I would go a little further and explain how to clean the nozzle. Use a paper clip or 20 gauge wire to push build up out. If that does not work use a small drill bit ( be careful to drill straight or you could damage the wall or jacket . This worked for me. Saved me $30. Had a problem locating this sight. Maybe some way to make it easier to locate would help. Thanks for your posting.

Mike Cunningham - Contestar

Do you know if I can soak this part in clr? I can't seem to clean it well enough.

Kelsey Harper -

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 22

Ultimos 30 días: 70

Todo El Tiempo: 4,408