Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unwrap the power cord from the handle.
-
Remove the 56.0 mm Phillips head #2 screw located above the water tank cap.
-
Pull the handle to separate it from the body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body.
-
Remove the plastic cap.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 16.0 mm T10 Torx screws near the top of the body and remove the water tank cap.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove steam control button cover with a metal spudger.
-
Remove the two 12.0 mm Phillips head #2 screws underneath.
-
Remove the plastic rim with clear plastic cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the Shark logo decal on the front of body using a metal spudger.
-
Remove the two 12.0 mm Phillips head #2 screws underneath.
-
Pull out the plastic cover to remove.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pop off the grey front plate to expose the control panel and screws necessary to open mop body.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 12.0 mm Philips head #2 screws connected to the dark grey plastic trim.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 16.0 mm T10 Torx screws located on the back of the mop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 12.0 mm Phillips head #2 screws that hold the power cord to the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pop open the white plastic mop body by pulling apart from the front and back side.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 12.0 mm Phillips head #2 screws on the sides of the heating element.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull out the heating element and use precision tweezers or pliers to pinch and loosen the two clamps.
-
Remove both tubes from the heating element.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grip each wire at its base and pull to disconnect them from the heating element.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove two 12.0 mm Phillips head #2 screws from the heating element.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull apart wire connectors to fully detach the heating element.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.
6 comentarios
Is the heating element available somewhere? I cannot find it anywhere.
Where can the heating element be purchased in order to replace? Can’t find anywhere.
i have a shark s3973d. and i need a heating elementand the two hosese connected
to the heating element. if no heating element. would like to order the hoses.
Once element is detached where do I get a new one
I just bought this shark steam vac less than 6months ago