Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unwrap the power cord from the handle.
-
Remove the 56.0 mm Phillips head #2 screw located above the water tank cap.
-
Pull the handle to separate it from the body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body.
-
Remove the plastic cap.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 16.0 mm T10 Torx screws near the top of the body and remove the water tank cap.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove steam control button cover with a metal spudger.
-
Remove the two 12.0 mm Phillips head #2 screws underneath.
-
Remove the plastic rim with clear plastic cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the Shark logo decal on the front of body using a metal spudger.
-
Remove the two 12.0 mm Phillips head #2 screws underneath.
-
Pull out the plastic cover to remove.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pop off the grey front plate to expose the control panel and screws necessary to open mop body.
-
Un comentario
Here is a video to help with dismantling if you'd like to see the possible original guide first posted on YouTube by George Robles September 16, 2015 years before.
No one knew or posted before me because I looked everywhere and why I created the video.
But I am curious where you got your information from if it was not my video.