Fix Your Stuff

Right to Repair

Parts & Tools

Shark Professional Steam Pocket Mop Front Panel Disassembly

Escrito Por: Brett Wilson (y 2 de otros participantes)
Publicado: May 21, 2018
  • Comentarios: 0
  • Favoritos: 0
  • Vistas: 749

Desmontaje

Herramientas Destacadas en este Teardown

Comprar estas herramientas

Introducción

This guide will start with opening the front panel. This will expose the control panel and more screws for further disassembly. Before doing any disassembly on your Shark Professional Steam Pocket Mop, make sure to unplug both the mop and empty the water tank for your safety.

Este desmontaje no es una guía de reparación. Para reparar tu Shark Professional Steam Pocket Mop, utiliza nuestros manuales de servicio .

  1. Unwrap the power cord from the handle. Remove the 56.0 mm Phillips head #2 screw located above the water tank cap.

    • Unwrap the power cord from the handle.

    • Remove the 56.0 mm Phillips head #2 screw located above the water tank cap.

    • Pull the handle to separate it from the body.

    Editar

  2. Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body. Remove the plastic cap. Remove the plastic cap.

    • Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body.

    • Remove the plastic cap.

    Editar

  4. Remove the three 16.0 mm T10 Torx screws near the top of the body and remove the water tank cap. The third screw is directly on other side of the bottom screw in the photo.

    • Remove the three 16.0 mm T10 Torx screws near the top of the body and remove the water tank cap.

    • The third screw is directly on other side of the bottom screw in the photo.

    Editar

  5. Remove steam control button cover with a metal spudger. Remove the two 12.0 mm Phillips head #2 screws underneath. Remove the plastic rim with clear plastic cover.

    • Remove steam control button cover with a metal spudger.

    • Remove the two 12.0 mm Phillips head #2 screws underneath.

    • Remove the plastic rim with clear plastic cover.

    Editar

  6. Remove the Shark logo decal on the front of body using a metal spudger. Remove the two 12.0 mm Phillips head #2 screws underneath. Pull out the plastic cover to remove.

    • Remove the Shark logo decal on the front of body using a metal spudger.

    • Remove the two 12.0 mm Phillips head #2 screws underneath.

    • Pull out the plastic cover to remove.

    Editar

  7. Pop off the grey front plate to expose the control panel and screws necessary to open mop body.

    • Pop off the grey front plate to expose the control panel and screws necessary to open mop body.

    Editar

Autor

con 2 otros colaboradores

Brett Wilson

Miembro Desde 12/02/18

848 Reputación

6 Guías creadas

Insignias: 11

+ 8 más insignias

Equipo

USF Tampa, Team S15-G1, Boczar Spring 2018 Miembro de USF Tampa, Team S15-G1, Boczar Spring 2018

USFT-BOCZAR-S18S15G1

4 Miembros

7 Guías creadas

0 comentarios

Agregar un comentario

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 6

Ultimos 30 días: 19

Todo El Tiempo: 749