Shark Navigator Lightweight Upright Motor Replacement

Introducción

The motor is the powerhouse behind your brush head rotation which could either increase or decrease your vacuum's cleaning power. This guide will take you through the necessary steps to properly replace your motor.

Qué necesitas

Paso 1 Head Shell

Shark Navigator Lightweight Upright Motor Replacement, Head Shell: paso 1, imagen 1 de 2

Shark Navigator Lightweight Upright Motor Replacement, Head Shell: paso 1, imagen 2 de 2

Detach the hose connected on the bottom of the vacuum by pulling it out of the casing.

Editar

Paso 2

Lay the vacuum on its side.
Press in the black, rubberish button located on the back of the vacuum to detach the vacuum head from the body.

Editar

Paso 3

Flip over the vacuum head so the brush head is facing up.

Editar

Paso 4

Shark Navigator Lightweight Upright Motor Replacement: paso 4, imagen 3 de 3

Remove the small front wheels with a metal spudger by inserting the metal spudger in front of the wheel and slowly prying up. This will free the wheel and reveal the screw beneath it.
Repeat this for the other wheel.

Editar

Paso 5

Remove the two 18mm screws with a JIS 1 screwdriver.

Editar

Paso 6

Remove the four 18mm screws located on the top corners and the bottom/middle of the vacuum head using a JIS 1 screwdriver.

Editar

Paso 7

Remove the two 18mm screws located on the inside of the large wheels using a JIS 1 screwdriver.

Editar

Paso 8

Shark Navigator Lightweight Upright Motor Replacement: paso 8, imagen 3 de 3

Remove the plastic cover by prying the plastic cover up using a plastic opening tool.
Prying in multiple locations may be necessary to create separation.

Editar