Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Replace the battery when the vacuum does not turn on even after charging.

Herramientas

No se especificaron herramientas.

  1. Turn the device over to reveal the bottom of the motorized brush head.
    • Turn the device over to reveal the bottom of the motorized brush head.

  2. Slide the latch next to the panel upwards into the unlocked position. Slide the latch next to the panel upwards into the unlocked position.
    • Slide the latch next to the panel upwards into the unlocked position.

  3. Slide the panel to the right to reveal the battery.
    • Slide the panel to the right to reveal the battery.

  4. Pull the battery from the vacuum. Pull the battery from the vacuum.
    • Pull the battery from the vacuum.

  5. Disconnect the battery from the vacuum by pinching the white latch and pulling the two pieces apart. Disconnect the battery from the vacuum by pinching the white latch and pulling the two pieces apart.
    • Disconnect the battery from the vacuum by pinching the white latch and pulling the two pieces apart.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Zachary Liu

Miembro Desde 24/01/18

559 Reputación

5 Guías creadas

Equipo

Cal Poly, Team S1-G5, Livingston Winter 2018 Miembro de Cal Poly, Team S1-G5, Livingston Winter 2018

CPSU-LIVINGSTON-W18S1G5

3 Miembros

5 Guías creadas

How much is the part for the shark

sumi49 - Contestar

My Shark SV1106 doesn’t stay on very long. One episode you turn it on it immediately turns off. So what is the issue?

jklab23 - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 58

Ultimos 30 días: 184

Todo El Tiempo: 5,996