Repara tus cosas Comunidad Tienda

Shark Flex DuoClean Suction Motor Replacement

Introducción

Following this guide requires cutting wires and soldering. For more information on soldering visit the soldering guide.

Qué necesitas

  1. Shark Flex DuoClean Suction Motor Replacement, Dust Cup: paso 1, imagen 1 de 2 Shark Flex DuoClean Suction Motor Replacement, Dust Cup: paso 1, imagen 2 de 2

    • Squeeze Dust Cup release buttons on either side of the component.

    • Pull up to release Dust Cup.

    Editar

  2. Shark Flex DuoClean Suction Motor Replacement, Suction Motor: paso 2, imagen 1 de 1

    • Remove the five 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.

    Editar

  3. Shark Flex DuoClean Suction Motor Replacement: paso 3, imagen 1 de 1

    • Use the iFixit opening tool to remove the top component.

    Editar

  5. Shark Flex DuoClean Suction Motor Replacement: paso 4, imagen 1 de 1

    • Remove the two 15mm screws by twisting counterclockwise using the T10 Torx screwdriver.

    Editar

  6. Shark Flex DuoClean Suction Motor Replacement: paso 5, imagen 1 de 1

    • Remove the two 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.

    Editar

  7. Shark Flex DuoClean Suction Motor Replacement: paso 6, imagen 1 de 1

    • Remove the two 15 mm screws holding the motor cover by twisting counterclockwise with a T10 Torx screwdriver.

    Editar

  8. Shark Flex DuoClean Suction Motor Replacement: paso 7, imagen 1 de 1

    • Cut the zip ties holding the motor using the wire cutter.

    Editar

  9. Shark Flex DuoClean Suction Motor Replacement: paso 8, imagen 1 de 1

    • Cut the wires using the wire cutters to completely remove the motor.

    • For reassembly, use the soldering guide in the Introduction.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 2 otros colaboradores

Christian Fuller

Miembro Desde 10/08/18

420 Reputación

3 Guías creadas

Insignias: 11

+ 8 más insignias

Equipo

Cal Poly, Team S17-G5, White Fall 2018 Miembro de Cal Poly, Team S17-G5, White Fall 2018

CPSU-WHITE-F18S17G5

4 Miembros

14 Guías creadas

Un comentario

how i need to know how to re connect the wires on replacing a new motor, my model is similar HV321.

andrea - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 10

Ultimos 30 días: 27

Todo El Tiempo: 3,479