Introducción

Following this guide requires cutting wires and soldering. For more information on soldering visit the soldering guide.

  1. Squeeze Dust Cup release buttons on either side of the component.
    • Squeeze Dust Cup release buttons on either side of the component.

    • Pull up to release Dust Cup.

    Agregar Comentario

  2. Remove the five 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.
    • Remove the five 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.

    Agregar Comentario

    • Use the iFixit opening tool to remove the top component.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Remove the two 15mm screws by twisting counterclockwise using the T10 Torx screwdriver.

    Agregar Comentario

    • Remove the two 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.

    Agregar Comentario

    • Remove the two 15 mm screws holding the motor cover by twisting counterclockwise with a T10 Torx screwdriver.

    Agregar Comentario

    • Cut the zip ties holding the motor using the wire cutter.

    Agregar Comentario

    • Cut the wires using the wire cutters to completely remove the motor.

    • For reassembly, use the soldering guide in the Introduction.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

Cal Poly, Team S17-G5, White Fall 2018 Miembro de Cal Poly, Team S17-G5, White Fall 2018

CPSU-WHITE-F18S17G5

4 Miembros

11 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 9

Últimos 30 Días: 15

Todo El Tiempo: 35