Saltar al contenido principal

Shark Flex DuoClean Power Cord Replacement

Qué necesitas

  1. Shark Flex DuoClean Power Cord Replacement, Dust Cup: paso 1, imagen 1 de 2 Shark Flex DuoClean Power Cord Replacement, Dust Cup: paso 1, imagen 2 de 2
    • Squeeze Dust Cup release buttons on either side of the component.

    • Pull up to release Dust Cup.

  2. Shark Flex DuoClean Power Cord Replacement, Power Cord: paso 2, imagen 1 de 2 Shark Flex DuoClean Power Cord Replacement, Power Cord: paso 2, imagen 2 de 2
    • Remove the pre-motor filter with your hands.

  3. Shark Flex DuoClean Power Cord Replacement: paso 3, imagen 1 de 1
    • Remove the post-motor filter.

  4. Shark Flex DuoClean Power Cord Replacement: paso 4, imagen 1 de 1
    • Remove the two 15 mm screws by twisting counterclockwise with the T10 Torx screwdriver.

  5. Shark Flex DuoClean Power Cord Replacement: paso 5, imagen 1 de 2 Shark Flex DuoClean Power Cord Replacement: paso 5, imagen 2 de 2
    • Remove the two 12 mm screws by twisting counterclockwise with the T15 Torx screwdriver.

    • To fully remove the power cord, cut the wires using a wire cutter.

    • For reassembly, use the soldering guide in the Introduction.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

caoimhe

Miembro Desde 10/08/18

979 Reputación

4 Guías creadas

Equipo

Cal Poly, Team S17-G5, White Fall 2018 Miembro de Cal Poly, Team S17-G5, White Fall 2018

CPSU-WHITE-F18S17G5

4 Miembros

14 Guías creadas

Un comentario

I found with further dissasembly, uncrimping and recrimping the wiring loom saved having to add more connections.

qwazew - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 10

Todo El Tiempo: 1,376