Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the garage door by sliding both of the release buttons away from you.
-
Lift off the garage door.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the plastic screw covering using a metal spudger by pushing the sharp side into the crevice and prying the cover out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the T10 Security Torx screwdriver counterclockwise to remove the 15mm screw.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the iFixit Opening Tool to pry the side of the vacuum open.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 15 mm T10 screws on the underside of the vacuum.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the plastic spudger, pry the back seam of the top component to pop it off the vacuum.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove one 15mm T10 screw from the inside left of the base of the vacuum to access the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the nylon spudger, place the curved side under the motherboard.
-
Gently pry the motherboard out of the base of the vacuum.
-