Introducción

We all know that the Sega Genesis brought to us many hours of fun, but, as we get older, the reset button gets older too.

Today, let's lend a hand to our nice friend and replace its reset button!

Partes

No se requieren partes.

Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
  • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

Agregar Comentario

Flip the Sega Genesis upright.
  • Flip the Sega Genesis upright.

Agregar Comentario

  • Gently lift the top casing.

  • Note: the case will be connected to the main board by LED wires.

Agregar Comentario

  • Bend out the LED leads into vertical positions.

Agregar Comentario

  • Slide the LED wire apparatus off the lead pins.

  • Note: observe which color wire corresponds with which length of pin.

Agregar Comentario

  • Separate the main board from the outer case.

Agregar Comentario

  • Using Philips screwdriver, remove 11 screws securing silver casing.

Agregar Comentario

  • Remove silver case.

Agregar Comentario

  • Locate reset button on motherboard

Agregar Comentario

  • Place three pieces of 1cm x 1cm masking tape over reset button.

You could also, if you feel confident in your skills, desolder the old button and replace it with a standard 4-pin pushbutton. Resolder the new one, and it should work.

Tsaku - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order. And the most important, be happy!

Una persona más ha completado esta guía.

calvin

Miembro Desde 05/10/10

186 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 3-29, Regan Fall 2010 Miembro de Cal Poly, Team 3-29, Regan Fall 2010

CPSU-REGAN-F10S3G29

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 2

Últimos 7 Días: 14

Últimos 30 Días: 67

Todo El Tiempo: 11,409