Saltar al contenido principal

Introducción

This repair guide will take you through all the steps for removing the outer case of the Sega Genesis.

Partes

No se especificaron partes.

  1. Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
    • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

  2. Flip the Sega Genesis upright.
    • Flip the Sega Genesis upright.

  3. Gently lift the top casing.
    • Gently lift the top casing.

    • Note: the case will be connected to the main board by LED wires.

  4. Bend out the LED leads into vertical positions.
    • Bend out the LED leads into vertical positions.

  5. Slide the LED wire apparatus off the lead pins.
    • Slide the LED wire apparatus off the lead pins.

    • Note: observe which color wire corresponds with which length of pin.

  6. Separate the main board from the outer case.
    • Separate the main board from the outer case.

Conclusión

To reassemble your device, follow these instructions in reverse order.

11 personas más completaron esta guía.

Equipo

Cal Poly, Team 3-29, Regan Fall 2010 Miembro de Cal Poly, Team 3-29, Regan Fall 2010

CPSU-REGAN-F10S3G29

4 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 21

Ultimos 30 días: 98

Todo El Tiempo: 15,619