Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Partes y herramientas

Partes

No se especificaron partes.

  1. Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
    • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

  2. Flip the Sega Genesis upright.
    • Flip the Sega Genesis upright.

  3. Gently lift the top casing.
    • Gently lift the top casing.

    • Note: the case will be connected to the main board by LED wires.

  4. Bend out the LED leads into vertical positions.
    • Bend out the LED leads into vertical positions.

  5. Slide the LED wire apparatus off the lead pins.
    • Slide the LED wire apparatus off the lead pins.

    • Note: observe which color wire corresponds with which length of pin.

  6. Kits para Nintendo Switch

    Una solución rápida para volver al juego

    Comprar kits de Switch

    Kits para Nintendo Switch

    Una solución rápida para volver al juego

    Comprar kits de Switch
  7. Separate the main board from the outer case.
    • Separate the main board from the outer case.

  8. Remove single black screw from the outside of the bottom cover, using a Philips screwdriver.
    • Remove single black screw from the outside of the bottom cover, using a Philips screwdriver.

  9. Using a Philips screwdriver, remove 11 screws securing silver casing.
    • Using a Philips screwdriver, remove 11 screws securing silver casing.

  10. Remove silver case.
    • Remove silver case.

  11. Remove single golden screw on motherboard using Philips screwdriver.
    • Remove single golden screw on motherboard using Philips screwdriver.

    • Note: Push headphone jack to the side.

  12. Remove two black screws on the left and right sides of the cartridge slot.
    • Remove two black screws on the left and right sides of the cartridge slot.

  13. Remove motherboard.
    • Remove motherboard.

  14. Re-install new motherboard.
    • Re-install new motherboard.

Conclusión

To reassemble your device, follow these instructions in reverse order.

10 personas más completaron esta guía.

Equipo

Cal Poly, Team 3-29, Regan Fall 2010 Miembro de Cal Poly, Team 3-29, Regan Fall 2010

CPSU-REGAN-F10S3G29

4 Miembros

11 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 7

Ultimos 7 días: 35

Ultimos 30 días: 143

Todo El Tiempo: 23,538