Partes

No se requieren partes.

Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
  • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

Agregar Comentario

Flip the Sega Genesis upright.
  • Flip the Sega Genesis upright.

Agregar Comentario

  • Gently lift the top casing.

  • Note: the case will be connected to the main board by LED wires.

Agregar Comentario

  • Bend out the LED leads into vertical positions.

Agregar Comentario

  • Slide the LED wire apparatus off the lead pins.

  • Note: observe which color wire corresponds with which length of pin.

Agregar Comentario

  • Separate the main board from the outer case.

Agregar Comentario

  • Remove single black screw from the outside of the bottom cover, using a Philips screwdriver.

Agregar Comentario

  • Using a Philips screwdriver, remove 11 screws securing silver casing.

Agregar Comentario

  • Remove silver case.

Agregar Comentario

  • Remove single golden screw on motherboard using Philips screwdriver.

  • Note: Push headphone jack to the side.

Agregar Comentario

  • Remove two black screws on the left and right sides of the cartridge slot.

Agregar Comentario

  • Remove motherboard.

Agregar Comentario

  • Re-install new motherboard.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

9 personas más completaron esta guía.

Equipo

Cal Poly, Team 3-29, Regan Fall 2010 Miembro de Cal Poly, Team 3-29, Regan Fall 2010

CPSU-REGAN-F10S3G29

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 10

Últimos 7 Días: 42

Últimos 30 Días: 165

Todo El Tiempo: 19,958