Introducción

A complete guide to replacing the main board.

Partes

No se requieren partes.

Place your device upside down and locate the two battery compartments.
  • Place your device upside down and locate the two battery compartments.

Agregar Comentario

Press on the tabs at the bottom of the battery covers then lift up to remove.
  • Press on the tabs at the bottom of the battery covers then lift up to remove.

  • Remove batteries if they are present.

Agregar Comentario

  • Remove the following screws:

    • Seven Phillips scres

    • One 4.5 mm Gamebit screw

Agregar Comentario

  • Use tweezers to take all other screws out.

Agregar Comentario

  • Gently open the case by unfolding it over the top of the Sega Game Gear.

  • Do not pull the back of the case away, as cables are connected between both sides.

Agregar Comentario

  • Carefully unplug the 2 white-tipped connectors on the top cover.

Agregar Comentario

  • Unscrew all the marked screws.

Agregar Comentario

  • Slide the logic board out from under the circular black fastener at the top-left corner of the case.

Agregar Comentario

  • Place the logic board on a flat surface.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

6 personas más completaron esta guía.

Brandon Page

Miembro Desde 15/04/10

130 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 28-33, Regan Spring 2010 Miembro de Cal Poly, Team 28-33, Regan Spring 2010

CPSU-REGAN-S10S28G33

5 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 3

Últimos 7 Días: 32

Últimos 30 Días: 121

Todo El Tiempo: 14,619