Saltar al contenido principal

Sega Dreamcast Fan Replacement

Qué necesitas

  1. Sega Dreamcast Fan Replacement, Expansion Bay: paso 1, imagen 1 de 2 Sega Dreamcast Fan Replacement, Expansion Bay: paso 1, imagen 2 de 2
    • Verify that the console is disconnected from the AC outlet before you begin.

    • Flip the console over on its back.

    • Take note of your model number, in case replacement parts are needed.

  2. Sega Dreamcast Fan Replacement: paso 2, imagen 1 de 3 Sega Dreamcast Fan Replacement: paso 2, imagen 2 de 3 Sega Dreamcast Fan Replacement: paso 2, imagen 3 de 3
    • Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console.

  3. Sega Dreamcast Fan Replacement, Top Cover: paso 3, imagen 1 de 1
    • Locate and remove all four black 12mm Phillips #02 screws from the underside of the console.

    • Note: Remove the expansion bay to locate the fourth screw

  4. Sega Dreamcast Fan Replacement: paso 4, imagen 1 de 1
    • Internal components can be loose. Be careful that they do not fall out when removing the cover.

    • Turn the console right side up.

    • Remove the top cover by gently lifting the upper portion of the console.

  5. Sega Dreamcast Fan Replacement, Fan: paso 5, imagen 1 de 1
    • Remove the white fan header by gently pulling it away from from the controller port.

    • The white fan header may already be detached if you have completed the Controller Port Disassembly Guide.

  6. Sega Dreamcast Fan Replacement: paso 6, imagen 1 de 1
    • Remove the two 8.5mm Philips #00 screws from the fan bracket.

  7. Sega Dreamcast Fan Replacement: paso 7, imagen 1 de 2 Sega Dreamcast Fan Replacement: paso 7, imagen 2 de 2
    • Remove the two 17.5mm Philips #00 screws from the fan bracket.

    • Remove the fan from the bracket.

  8. Sega Dreamcast Fan Replacement, Fan: paso 8, imagen 1 de 2 Sega Dreamcast Fan Replacement, Fan: paso 8, imagen 2 de 2
    • Connect the new fan to the fan bracket using two 17.5mm Philips #00 screws.

    • Replace the fan bracket in the Dreamcast using two 8.5mm Philips #00 screws.

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Thorr686

Miembro Desde 11/06/09

472 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 5-1, Regan Fall 2009 Miembro de Cal Poly, Team 5-1, Regan Fall 2009

CPSU-REGAN-F09S5G1

5 Miembros

21 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 14

Ultimos 30 días: 38

Todo El Tiempo: 18,802