Repara tus cosas Comunidad Tienda

Sega CD CD Tray Replacement

Qué necesitas

  1. Sega CD CD Tray Replacement, Sega CD Plastic Housing Removal: paso 1, imagen 1 de 2 Sega CD CD Tray Replacement, Sega CD Plastic Housing Removal: paso 1, imagen 2 de 2

    • Using a Phillips head screwdriver remove six screws from the bottom of the console.

    • The six screws are marked.

    Editar

  2. Sega CD CD Tray Replacement: paso 2, imagen 1 de 1

    • Remove the two screws that attach the Genesis' connector to the rest of the console.

    • The two screws are marked in the diagram.

    Editar

  3. Sega CD CD Tray Replacement: paso 3, imagen 1 de 1

    • Slide the lock tab to the left to separate the halves of the console.

    Editar

  4. Sega CD CD Tray Replacement: paso 4, imagen 1 de 1

    • Lift from the left side to remove the top of the case.

    Editar

  5. Sega CD CD Tray Replacement: paso 5, imagen 1 de 1

    • Using the spudger, pry the cover off of the Genesis attachment.

    Editar

  7. Sega CD CD Tray Replacement: paso 6, imagen 1 de 1

    • Lift the top of the case to remove the cover.

    Editar

  8. Sega CD CD Tray Replacement: paso 7, imagen 1 de 1

    • Remove the faceplate by pulling it up, then out.

    Editar

  9. Sega CD CD Tray Replacement, CD Tray: paso 8, imagen 1 de 2 Sega CD CD Tray Replacement, CD Tray: paso 8, imagen 2 de 2

    • Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.

    • The three screws are shown on the diagram.

    Editar

  10. Sega CD CD Tray Replacement: paso 9, imagen 1 de 2 Sega CD CD Tray Replacement: paso 9, imagen 2 de 2

    • Remove the two screws from the plastic bar.

    • The two screws are shown pictured.

    Editar

  11. Sega CD CD Tray Replacement: paso 10, imagen 1 de 2 Sega CD CD Tray Replacement: paso 10, imagen 2 de 2

    • To remove the CD tray

    • Remove the four screws with the Phillips head screwdriver.

    Editar

  12. Sega CD CD Tray Replacement: paso 11, imagen 1 de 1

    • Carefully unplug the wire connected to optical reader.

    Editar

  13. Sega CD CD Tray Replacement: paso 12, imagen 1 de 2 Sega CD CD Tray Replacement: paso 12, imagen 2 de 2

    • Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver.

    • The four screws are highlighted on the diagram.

    • The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws.

    Editar

  14. Sega CD CD Tray Replacement: paso 13, imagen 1 de 1

    • Carefully remove the CD tray from circuit board.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 9 otros colaboradores

sskyllin

Miembro Desde 10/18/10

21 Reputación

2 Guías creadas

Insignias: 5

+ 2 más insignias

Equipo

Cal Poly, Team 5-14, Maness Fall 2010 Miembro de Cal Poly, Team 5-14, Maness Fall 2010

CPSU-MANESS-F10S5G14

4 Miembros

12 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 8

Ultimos 30 días: 38

Todo El Tiempo: 9,582