Introducción
Use this guide to access the Flash Mechanism so it can be replaced.
Qué necesitas
-
-
Remove the following six screws using the Phillips #00 screwdriver:
-
Two screws on the left side of the camera.
-
Two screws on the right side of the camera.
-
Two screws on the bottom of the camera.
-
-
-
Using the spudger, carefully lift up the LCD screen, making sure to keep the ribbon cable intact.
-
Place the LCD screen on a non-abrasive surface.
-
-
-
-
Using the Phillips #00 screwdriver, remove the four screws on the outer edge of the LCD holding plate.
-
-
-
Using the capacitor discharge tool carefully touch each end of the capacitor discharge tool to the each terminal of the capacitor.
-
Click the link below for instructions on how to make the capacitor discharge tool: Construir una herramienta para descargar un condensador
-
Keep the wires connected to the capacitor terminals for 2 minutes to completely discharge the capacitor.
-
The camera should be completely safe to handle now.
-
-
-
Touch the soldering iron tip to the solder in the upper right corner connecting the logic board to the battery lead.
-
Pull the battery lead out of the slot in the logic board. This must be done immeadiately after the solder melts.
-
Repeat for the solder to the left.
-
The logic board will now be completely free from the camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.