Saltar al contenido principal

Introducción

Use this guide to remove or replace the case.

Partes

No se especificaron partes.

  1. Place your thumb on the right side of the camera over the battery door.
    • Place your thumb on the right side of the camera over the battery door.

    • Slide the battery door to the right until the door lifts up.

  2. Remove and recycle old batteries.
    • Remove and recycle old batteries.

  3. Unscrew 6 Phillips screws using the #00 Phillips screwdriver. Two screws are on the left side of the camera. Two screws are on the right side of the camera.
    • Unscrew 6 Phillips screws using the #00 Phillips screwdriver.

    • Two screws are on the left side of the camera.

    • Two screws are on the right side of the camera.

    • Two screws are on the bottom of the camera.

  4. Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now

    Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now
  5. Open battery slot on the bottom of the camera by sliding the door to the right. Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.
    • Open battery slot on the bottom of the camera by sliding the door to the right.

    • Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.

  6. Insert spudger in the seam at the bottom of the camera. Gently separate the rear case from the front of the camera. Gently separate the rear case from the front of the camera.
    • Insert spudger in the seam at the bottom of the camera.

    • Gently separate the rear case from the front of the camera.

  7. This step is only needed for the case and logic board replacement
    • This step is only needed for the case and logic board replacement

    • Using the #00 phillips screwdriver remove the screw attached to the front casing in the top left corner. Front case should easily separate.

  8. This step is only needed for the case replacement.
    • This step is only needed for the case replacement.

    • Using the #00 phillips screwdriver remove the screw on the inside of the battery door.

    • Slide the battery door off of the hinge.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

Cal Poly, Team 24-24, Regan Spring 2010 Miembro de Cal Poly, Team 24-24, Regan Spring 2010

CPSU-REGAN-S10S24G24

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 1,776